- 2.8 inch display for quick viewing
- Waterproof for cycling in all weather
- Convenient backlighting (Backlight color: White or Green)
- Standby mode (Choose between full-power and power-saving modes by pressing the “M” key)
- Low power consumption
- Models: Wired or wireless
- Colors: Black
- Power supply: 2030 battery
- Installation location: Bike handlebars
- Application: bicycle or tricycle
Packaging:
Standard ( wired )
• 1 x Cycling monitor
• 1 x Wired base
• 1 x Magnetic head
• 6 x Nylon ribbon
• 1 x Manual
• 2 x Sponge Pad
• 1 x 2032 battery
Standard (wireless)
• 1 x Cycling monitor
• 1 x Wireless base
• 1 x Wireless inductor
• 1 x Magnetic head
• 6 x Nylon ribbon
• 1 x Manual
• 2 x Sponge Pad
• 1 x 2032 battery
Extension mount (wired)
• 1 x Cycling monitor (battery inside)
• 1 x wired extension mount
• 1 x Magnetic head
• 6 x Nylon ribbon
• 1 x Manual
• 2 x Sponge Pad
Extension mount (wireless)
• 1 x Cycling monitor (battery inside)
• 1 x Wireless extension mount
• 1 x Wireless inductor
• 1 x Magnetic head
• 6 x Nylon ribbon
• 1 x Manual
• 2 x Sponge Pad
Magnetic head and inductor installation, extension mount installation
Wired installation
1. Screw the magnet into place
2. Adjust the distance between the magnet and the sensor (1.5 to 5 mm)
3. Aim the magnet toward the upper and lower ends of the sensor
Wireless installation
1. Adjust the distance between the transmitter and the monitor to within 60 mm
2. Adjust the distance between the transmitter and the magnet to within 3 mm
3. Aim the transmitter arrow toward the magnet
Wired or wireless installation options
Wired bicycle computer installation
1. Attach the base to the handlebars
2. Fix the monitor to the base
3. Wrap the wires around the brake wire to the wheel
4. Fix the magnets to a spoke
5. Attach the sensor to the wheel fork
6. Adjust the distance between the magnet and sensor to within 3 mm
Wireless bicycle computer installation
1. Attach the base to the handlebars
2. Fix the monitor to the base
3. Loosely attach the magnet to a spoke
4. Attach the wireless sensor using the wraps
5. Adjust the distance between magnet and sensor to within 3 mm
Base assembly
Remove the screws from the base and switch directions depending on your installation method
